Forum Discussion

Jerry_B's avatar
Jerry_B
Explorer
Nov 25, 2013

Sealand Revolution 320 Toilet

My current Sealand 210 toilet is too low and has been problematic. So, I'm thinking of replacing it with the new Sealand revolution 320 high profile toilet. The current sealand wobbles a little and I am curious if the new higher profile job will wobble even more. Anyone have any experience with this toilet. Thanks.
  • WeBeFulltimers's avatar
    WeBeFulltimers
    Explorer
    Nov 28, 2013
    It surprises me that a Mobile Suites would have a low-end toilet like the 210 in it. Was it from the factory? :h
  • Jerry_B's avatar
    Jerry_B
    Explorer
    Nov 26, 2013
    Thanks OB. I had the 210 off and apart to replace the ball valve and gaskets. There are two attaching bolts into the floor ring and two lag bolts aft screwed into the floor. The bolts are pretty tight. I am concerned about breaking the floor ring or stripping the lag bolts.
  • Old-Biscuit's avatar
    Old-Biscuit
    Explorer III
    Nov 25, 2013
    Dometic 320 Installation Video.....LINK

    The old toilet wobbling is probably due to toilet to floor flange bolts being loose, floor flange installed too high (bottom of flange should rest on floor) or floor flange not secured to floor.

    You won't know about the floor flange until you remove old toilet.
    You can check the toilet bolt tightness on old toilet.

    While you have the old toilet out....might want to install toilet water shutoff valve. Nice to be able to isolate toilet water without having to turn ALL water off.

    The 320 Is a nice upgrade from that 210. Good luck!

About Fifth Wheel Group

19,006 PostsLatest Activity: Jan 29, 2025