Vanleigh dining area - One slide inoperable

Have a switch arriving today hope that all it is

Try swapping switches. If the problem follows the switch, then the switch is the problem.

Thanks yes it’s removing the patch from underneath any ideas where I can get replacement fabric

I would imagine that the switch just reverses voltage, running the motor the opposite of when it comes in. So you could try reversing the switch wiring to see if that would make a difference, or check the motor where the wires connect and see if you have power on both wires when operating in and out. I agree that it's either the motor or the switch. Could be something as simple as a loose connection.

I have a third party warranty may be time to try it out if the switch doesn’t fix it

Opposite side to the slide where I had to crank it out,

Have a switch coming and any ideas why the motor would work to get the slide in but not out

I’m guessing the previous owner had to replace at some point looking at the patch underneath? Is this where the motor would be

Seeing that you have electric motors for the slides I will say either you have bad switch or motor.