What did you do to your Toy Hauler today???

I thought the Victory had more chrome than that!

I modified the Furion solar plug today. It is now a 12 volt power outlet.

I got it all modified and it would not work. There was no power. (the other end of the wires were not connected to the battery)







Davy Crockett Green Mountain Grill


I also installed the Lock N Load Deluxe Wheel Chock and CargoBuckle G3 retractable ratchet tie downs for the Victory XCT in the garage today. Best motorcycle wheel chock tie down kit

The toyhauler is in the driveway up (almost) against the house, so the bike is not going to be in the picture yet.

Out of storage and to CW for first preseason check

Another amazon package showed up today, my Delta faucet.

nayther wrote:

bkirkpatrick wrote:
Sold my tow vehicle.

Hope you've still got a truck to haul the toys!

2008 GMC Denali AWD. Just need to get a 22' flatbed and sell my 14' flatbed trailer.

Just got my package today from amazon, just installled a sink mount dish soap dispenser, super easy really clean look. $11 on amazon.

joebedford wrote:
I used these: Triangle T93007 from Amazon. They're only $8.49 for 5m - I needed two of them.

I hooked them to 12V. I ran a wire from my switch panel out over top of the galley slide. The electrical connection to the strips is in the middle above the slide. Essentially invisible from the ground.

I had 3 spare switch slots on the panel so I added a new lighted switch for independent operation of these lights.

Be aware that this particular brand is very blue / white. I don't mind it at all but others might not like it so much. You can get others that do colors and whatnot - not for me.

just ordered one plus a controller so I can dim it down if I want. Thanks for the link.

bkirkpatrick wrote:
Sold my tow vehicle.

Hope you've still got a truck to haul the toys!

Sold my tow vehicle.

I used these: Triangle T93007 from Amazon. They're only $8.49 for 5m - I needed two of them.

I hooked them to 12V. I ran a wire from my switch panel out over top of the galley slide. The electrical connection to the strips is in the middle above the slide. Essentially invisible from the ground.

I had 3 spare switch slots on the panel so I added a new lighted switch for independent operation of these lights.

Be aware that this particular brand is very blue / white. I don't mind it at all but others might not like it so much. You can get others that do colors and whatnot - not for me.