What did you do to your Toy Hauler today???

Total ramp de-construction, due to water damage. Got it down to the steel frame and will rebuild it completely.

EBX wrote:
Put three roof vent covers over the crank up vents to keep the rain out. Installed a full width handle on the screen door. Replaced the two 12" hoses that come off the two LP tanks that go into the switch over switch. Checked bearing grease. Installed four more stablizer jacks b/f and aft the tires. Replaced the pull handle on the black tank valve after I ran over a semi retread. Replaced the 15" rims and D rated tires with 16" rims and E rated tires for extra margin. Replaced the 27" tube tv with a 37" LCD. So much nicer and lighter. Put some more nickle plated hang hooks in the bedroom.

Best mod you made, I did it last fall and could not be happier with the way it handles, not to mention 4 trips now with no tire problems.

Measured for two 170w solar panels.

Just dropped off our jack knife sofas at an upholstery shop.

Put three roof vent covers over the crank up vents to keep the rain out. Installed a full width handle on the screen door. Replaced the two 12" hoses that come off the two LP tanks that go into the switch over switch. Checked bearing grease. Installed four more stablizer jacks b/f and aft the tires. Replaced the pull handle on the black tank valve after I ran over a semi retread. Replaced the 15" rims and D rated tires with 16" rims and E rated tires for extra margin. Replaced the 27" tube tv with a 37" LCD. So much nicer and lighter. Put some more nickle plated hang hooks in the bedroom.

Mounted my hinged license plate holder...

Put a new air filter/fuel filter/spark plug in the Onan.
All I have to do is look at the start button and She fires right up :W

Took the cover off, fired up the genset, checked all the systems...then sat in it, watched a little tv...and started thinking about where to go this year! Now I just have to put on my new hinged license plate holder. Suppose to be nice tomorrow..,hmmm

Thats awesome, now I know where to mount my 5 gal air tanks!

THANKS!

nayther wrote:
Finally got some pis of my compressor install. It's been in there for over a year but had the propane tanks out to fix the jack so thought I'd snap a couple of photos.



Here you can see a detail of how it's piped. I used a regular plumbing S.S. flex line to connect the tank to the PVC, then ran one pipe to each side plus the front with quick disconnects.

Started the gen and put a load on it for a while. Checked for leaks/damage over the past coupla months. Alllooked good. Spring can't come fast enough!