12V distribution question
Here is a sketch of what I want to do for 12V for review. Will the #8 wire with a 40A breaker from the isolater be an issue? The #8 wire is original. The schematic for the PD9145A shows 18" max to...
Forum Discussion
jjrbus wrote:
Here I am befuddled again! When I posted I believe I saw the sketch, now I am sitting looking at the sketch with my post. But it says post was edited by administrator?
Someday I will figure this out, what am I doing wrong? Jim
Your drawing was edited because it exceeded recommended 640 width. Some notepads will not properly download a drawing/picture that is to wide.
If you look at your original post within edit you will see that "width=640" was added to your img link.
