Forum Discussion

D_WILSON's avatar
D_WILSON
Explorer
May 17, 2019

7 PIN TOWING CONNECTOR

I DON'T HAVE POWER TO THE TAIL LIGHT PIN ON THE 7 PIN TOEING CONNECTOR ON THE REAR OF MY RV. ALL OF THE OTHER PINS WORK , BREAK LIGHTS , RIGHT TURN , LEFT TURN,& FLASHERS. IS THE 7 PIN CONNECTOR FUSED IN ANY WAY? AND IF SO WHERE ARE THE FUSSES FOR THE 7 PIN ?
ANY & ALL INPUT WOULD BE GREATLY APPRECIATED !!!

14 Replies

  • If the tail lights work on the rv but not through the connector, look for a problem in the wiring between the rear rv lights and your connector. The rv lights are fused but they are generally not fused past that point.
  • Not sure about your MH but most trucks come pre wired for 12V power to the 7 pin plug. The lead is usually next to but not connected to the battery or in some cases is connected but a relay is missing (not plugged in) to complete the circuit. Check for a wire hanging near the MH battery with an eyelet. It also could be connected but the fuse not plugged in.
    It may be mentioned in the MH operator manual re: the 7 pin plug. The manual should describe the fuse block and its location.
  • 1. No the 7 pin is not fused.
    2. Please don't type in all caps.
    3. Welcome to the forum.

    Click HERE for more troubleshooting help....Dennis
  • THE FUSSES COULD BE ALMOST ANYWHERE. I FOUND MINE ON THE BATTERY. THEN AGAIN THE TOEING CONNECTER COULD BE FAULTY. GOOD THING THE BREAKS WORK.