Atwood g10-3e question no power at switch
Atwood g10-3e no power at switch or outside at unit, but fuse is good. Does anyone know if the power goes through the switch before going to unit? Could my switch be bad? It's the type of switch wit...
Forum Discussion
G10-3E is a propane only WH.
Depends on where t-stats are located.....front or rear of WH
FRONT:
12V DC power comes from DC Dist. Panel (fused) to switch.
From switch to 'normal' t-stat and then back to circuit board (Brown wires)
From circuit board to ECO and then to gas valve solenoids (Red wires)
REAR:
12V DC power comes from DC Dsit. Panel (Fused) to switch
From switch to ECO to normal t-stats (White wire) and then to circuit board (Brown wire)
From circuit board to gas valve solenoid (Red wire)
Depends on where t-stats are located.....front or rear of WH
FRONT:
12V DC power comes from DC Dist. Panel (fused) to switch.
From switch to 'normal' t-stat and then back to circuit board (Brown wires)
From circuit board to ECO and then to gas valve solenoids (Red wires)
REAR:
12V DC power comes from DC Dsit. Panel (Fused) to switch
From switch to ECO to normal t-stats (White wire) and then to circuit board (Brown wire)
From circuit board to gas valve solenoid (Red wire)
