Fun / Projects / with my 1997 America Dream
Borrowed a trailer and getting ready for some fun in the sun (it's cold here now 30's again tonight) I went and bought a 8 inch drop hitch, the 6 inch had the deck at too much of an angle, and ...
Forum Discussion
Gillig does not make name plates for their RV chassis.
I purchased the nameplate below off e-bay, it is 15 1/2 long by 4 1/2 wide.
I'm thinking of putting it on the body panel above the engine compartment doors in the lower right corner of that body panel, about the same height as the bottom of the latter on the opposite side. I am still look for a small emblem to put beside the entrance door like what the Prevost H3-45 does
I purchased the nameplate below off e-bay, it is 15 1/2 long by 4 1/2 wide.
I'm thinking of putting it on the body panel above the engine compartment doors in the lower right corner of that body panel, about the same height as the bottom of the latter on the opposite side. I am still look for a small emblem to put beside the entrance door like what the Prevost H3-45 does
