HWH Levelers-Final Fix?

Shot-N-Az wrote:
Doug, how difficult is it to remove and replace a jack cylinder? Are there directions posted anywhere?

For me it is not that big a deal:B There may be instructions on HWH's website. Doug

Doug, how difficult is it to remove and replace a jack cylinder? Are there directions posted anywhere?

Bumpyroad wrote:

J-Rooster wrote:
I had a similar problem several years ago and had to replace the one jack it cost me $750.00 including labor at CW.

sounds to me like they replaced the entire jack, not just the cylinder.
bumpy

That's about right for a NEW cylinder and the labor. Rebuilt is much better cost if you can wait for HWH to rebuild. It is a little high, but they would NOT replace the Complete Jack as the complete comes with the switches and the frame mount bracket. Check your receipt for how the breakdown is on the labor and part. Doug

bumpy, it does sound that way. some places do that just for the extra money.

J-Rooster wrote:
I had a similar problem several years ago and had to replace the one jack it cost me $750.00 including labor at CW.

sounds to me like they replaced the entire jack, not just the cylinder.
bumpy

I took an old toothbrush, some rags and WD-40 and cleaned all around the seal area on my slowly retracting jack. There was a lot of built up crud there, once it was cleaned out, the jack retracted fine.

May not solve your problem, but for a few minutes of your time and next to no cost, it's worth a try.

Best Regards!

I had a similar problem several years ago and had to replace the one jack it cost me $750.00 including labor at CW.

happy-2 wrote:
If you can get all jacks up check the fluid level FIRST.After fill up run up then down a few times. also check the springs, mite have a week spring, a spring is cheeper than a cylinder.

OK lets check off your response
1. WHAT does fluid level have to do with HWH jacks failing to retract????
2. Springs can be a factor but NOT if they are still installed and not broken. Springs(new style tapered ends) will bring the jacks up FASTER, but a weak older style spring will still retract a GOOD cylinder. You can push (retract) a HWH cylinder with moderate pressure from your hand with no springs attached. Doug

Doug is correct. The seals will harden up and need replacing. HWH will rebuild cylinders for a little over $100.00 per(price from 2010)

Cliff

Also, HWH does not recommend silicone sprays as a final solution or for retraction.

HWH INFORMATION BULLETIN ML47149 wrote:
If the jack rod has been greased or silicone sprays have been used on the jack rod, use WD-40 to loosen the grease or silicone and wipe the rod clean.

HWH INFORMATION BULLETIN ML47149