P30 Windshield Replacement Molding?
I've been doing a lot of research on getting the right molding to replace the old stuff on the windshield of an 88 Winnebago. It's of this style: The old one is coming off and it just so hap...
Forum Discussion
ok, thanks for the insights everyone! In the spirit of giving more knowledge for someone else searching this info out, I'll post the pics of where I removed the old moldings, and cleaned and prepped the surfaces for new.
I've found a source for molding, probably going to go with UM-3011BR 1.25inch Flexline molding. Will need to scrape more of the older urethane out of the crevices to install and reseal the new molding while leaving the windshield in place. There is no channel that the tab fits in as I mentioned earlier, it's all urethane glue.
top:
bottom:
I've found a source for molding, probably going to go with UM-3011BR 1.25inch Flexline molding. Will need to scrape more of the older urethane out of the crevices to install and reseal the new molding while leaving the windshield in place. There is no channel that the tab fits in as I mentioned earlier, it's all urethane glue.
top:
bottom:
