Replacing motor in Lippert slide
I need to replace a motor in my Lippert slide mechanism. It had a wire detach a quit working. I found this video by Lippert on how to do it but when you get to the point where they just lift the moto...
Forum Discussion
I got the slide out a couple of inches and the motor moves fairly freely an eigth of inch or so but then stops and I cannot move it any farther, even tapping it moderately with a hammer. I guess that I just need to wait until Tuesday and see if tech support can give me any worthwhile suggestions on how to proceed. I may even have to get the new motor to see how this one attaches. I was hoping to get the old motor out and have it in my hand when ordering the new one to be sure that I could get all of the numbers off of it.
