2005 Itasca Horizon 40ADOur right living room slide won't come in. You can hear the motor when you push the in button but nothing happens. Our left living room and bedroom slides work fine. Never had any problems before. We need to move the motorhome and need slide in. Coach is level with jacks down.Any help would be appreciated.

Try cranking the engine nd trying again. Sometimes that slide needs to have the battery a little more charged.

Not familiar with your slides but I'd look for a broken shear pin, key or other malfunction in the drive mechanism.

You are talking about the drivers side flat floor sldie aren't you. If the engine running does not help the have someone push on it while you push the button and once it gets up the ramp it should come right in.

We did try with the engine running and still won't come in.It's the right slide on passenger side. When you push the button you can here the motor but nothing happens. All other slides work fine. We did try pushing on slide while button was being pushed with no luck.

go here for helpOperator Manualshttp://www.winnebagoind.com/resources/manuals/operatormanuals.phpManuals & Diagramshttp://www.winnebagoind.com/resources/manuals/

Slide won't come in-help | Good Sam Community

dkreuzen
Explorer
Jun 07, 2013
powderman426 wrote:
If you can hear the motor running, that sure sounds like a shear pin has broken. :(

X2
RoyB
Explorer II
Jun 07, 2013
You would think there should be a manual crank somewhere for that model. Maybe it grabs the gear at a different spot where the motor engages...

Roy Ken
tropical36
Explorer
Jun 07, 2013
Bren53 wrote:
We did try with the engine running and still won't come in.

It's the right slide on passenger side. When you push the button you can here the motor but nothing happens. All other slides work fine. We did try pushing on slide while button was being pushed with no luck.

Is it total electric with a POWER GEAR unit perhaps? Does the motor have a lever (maybe enclosed in rubber) on the back to disengage the elect. brake. It could have been moved to the unlock position for manual operation inadvertently and especially if it's in a basement compartment.
powderman426
Explorer
Jun 07, 2013
If you can hear the motor running, that sure sounds like a shear pin has broken. :(
rr2254545
Explorer
Jun 07, 2013
go here for help

Operator Manuals
http://www.winnebagoind.com/resources/manuals/operatormanuals.php
Manuals & Diagrams
http://www.winnebagoind.com/resources/manuals/
Bren53
Explorer
Jun 07, 2013
We did try with the engine running and still won't come in.

It's the right slide on passenger side. When you push the button you can here the motor but nothing happens. All other slides work fine. We did try pushing on slide while button was being pushed with no luck.
Mike_and_Pat
Explorer
Jun 07, 2013
You are talking about the drivers side flat floor sldie aren't you. If the engine running does not help the have someone push on it while you push the button and once it gets up the ramp it should come right in.
Rich_D_
Explorer
Jun 07, 2013
Not familiar with your slides but I'd look for a broken shear pin, key or other malfunction in the drive mechanism.
Mike_and_Pat
Explorer
Jun 07, 2013
Try cranking the engine nd trying again. Sometimes that slide needs to have the battery a little more charged.

Forum Discussion

Slide won't come in-help

About Motorhome Group

Related Content

Slide vs no slide

HELP PLEASE!! Stranded in Jasper, GA

Sliding Hitch

Slide problem

Slides and More Slides