Steps stopped working

Well done!

As Effy mentioned, there are three grounds that all have to work right on my Kwikee. It's always a good place to start. I'm glad it only took 45 minutes to change the motor. You just pocketed your next fill up, Sweet!

Congrats! And thanks for coming back to tell us how it got fixed. You're well on the road to being a RV repair tech.

Update: stair fixed! Thanks to all for the advice and encouragement. This ended up being a great DIY project for a newbie. A couple of YouTube videos really helped.

Instead of dropping the typical grand at the repair shop, instead being sold a 400 dollar upgrade kit from the parts dealer, this ended up being a 65 dollar 45 minute job. 3 bolts and some grease. I did have to release the steps to get to the motor so that added some time.
Thanks again!

Hah! $360. They hope they've found a sucker. People who change the motor usually say how easy it was, and that they found a automotive window motor at a local automotive parts store when they brought their old step motor with them. Usually for under $50. Also people have found them at junk yards.

Personally, I just removed the step assembly (Kwikee 2-step unit), worked on it on the bench and found that after I cleaned everything up (just the electrical contacts) and greased the gears in the gear case there was nothing wrong with the motor.

Good luck to you though...

Update: I did manage to spend a few minutes in the 100+ degree weather to look at these steps. Thanks for the suggestions so far. I pulled the power connector to the motor and can see it going +/- 12V when I open and close the door. Light on the steps comes on as well.

So, considering I should just try and replace the motor. The current one is AME 214-1001. I 'think' I found a replacement on amazon Kwikee 1101428 Motor Replacement Kit ($65). They say it will replace this motor.

Then I called my local rv place and they are pushing an entire upgrade kit $360 plus tax. I'm curious if that is really needed. I can get the motor and the Kwikee 1101425 Gear/Linkage Assembly both total ~130 bucks. I'm not sure what else may be missing for such a price difference.

I think probably wise to do both.

Howard, I sent you a PM if you have anymore questions PM me back. Thanks, John

Here are a couple of photos of the location of the circuit breakers. Most folks don't know there are some between the floor and top house step. The black tab in the picture is used to pull a cover off the cover over the CBs. The battery disconnect is also there.

Ours did that once and it turned out that someone kicked the magnet loose on the door frame that tells the steps to go in and out.....all I did was to refasten the magnet and all worked well....

Here's a link to my step repair blog story. Sadly, I screwed up and didn't get any pictures when I had the gear box assembly opened up on the workbench.

Repairing Kwikee Steps

Thanks for the encouragement Jim@HiTek. Fortunately the steps were 95% retracted, so I just rigged up a step using a box of firewood, some foam pads and my grill cover....a little McIver-ish, but it was sound and did the job. Each trip has provided learning, so it gets better each time. Fixed the shower plumbing myself, replaced shades, upgraded tv electronics, wifi-HD, etc. The mechanical stuff causes me pause...but I figured this would be a good one to jump into. I crawled under on the trip, but decided to wait, then promptly left all the manuals back at storage. I know there's a fuse box under the dash when I hooked up a CB, so I just need to find which goes to which, and I have all electronic testing stuff, multimeters, leads, 14v PS, etc. Just gotta watch the fingers, as pointed out.

Gonna be 100+ dgrees here this weekend, so will look for a bit cooler weather before I take on something that will take three times as long as expected to figure out.
Asking the forum is probably my way of getting confirmation that I can do this!