toliet

I just changed our Aquamagic IV for an Aquamagic V last Xmas 2013. It is an exact replacement. Only thing we had to change was the rubber sealing donut that the toilet sits on.

The old one had two foot pedals to operate whilst the new one has only one foot pedal, 1/2 way for water, full to flush . The new one also has a kitchen type shower head for cleaning the bowl.

Took about 20 minutes start to finish.

P.S. It's best to have the holding tank flushed out and empty when you do the swap out.

Just replaced our low profile Thetford RV toilet with a Dometic 320 high profile all ceramic RV toilet, it fit the flange plate just fine. The Dometic 320 is the same fit and feel as the toilet in our house. No more looking for handhold to get up or fitting over the seat.

Direct replacement........Thetford Conversion Chart LINK

The bolts that hold the toilet down actually lock in to a floor flange and are somewhat adjustable. The water lines will be close enough that you can get a flex line from Home Depot if needed. Connectors on each end should be the same.