What did you do to your Class C MH today???
This is always a fun thread to watch in other forums, so I thought I'd start one here.
Forum Discussion
PR Connection wrote:Calisdad wrote:
Also put that shiny bubble insulation on the inside of the engine dog house. Just cut to fit then use spray adhesive. Tape and/or clamp insulation in place until adhesive sets. Really cuts the sound and heat down.
That stuff is not high temp rated and will probably melt when the weather is hot ..... might even cause a fire. Try using a heat gun on it and see what happens ..... it just shrivles up
JMO
Dan
Dan, thanks for pointing that out. I really didn't consider it. It's been in for some time now and several thousand miles with no problems but I'll sure keep an eye on it. Apparently its rated to 180 degrees but I can see how it might breakdown over time.
regards-
C-dad
