What did you do to your Class C MH today???
This is always a fun thread to watch in other forums, so I thought I'd start one here.
Forum Discussion
Got some stuff done.. adjusted the bathroom door so it latches, adjusted the screen door so it latches, tried to adjust the main door still not tight don't know of anyway to make it tight without cutting the frame. I wonder if they were even adjusted properly from the factory!
Put some rubber gasket squares on the cabinets so it'll be a bit quieter down the road. Started raining so got out the brush and started washing. Much easier to wash those bugs off in the rain. Managed to get off the orange from those cones in Louisiana. Hit the cones even though I was dragging the dual on the curb on the other side!
Going to go get the water heater element and tool tomorrow so hopefully will get that working. Will put a spigot on the water heater drain while I'm at it. After that may change out the male end on the short hose that came with RV. Think some tried to tighten it down with clamp-on's. Not sure what I'll do after all that.
Put some rubber gasket squares on the cabinets so it'll be a bit quieter down the road. Started raining so got out the brush and started washing. Much easier to wash those bugs off in the rain. Managed to get off the orange from those cones in Louisiana. Hit the cones even though I was dragging the dual on the curb on the other side!
Going to go get the water heater element and tool tomorrow so hopefully will get that working. Will put a spigot on the water heater drain while I'm at it. After that may change out the male end on the short hose that came with RV. Think some tried to tighten it down with clamp-on's. Not sure what I'll do after all that.
