Would a bug deflector work on a Class C?

The previous owner of our C had a bug shield. It wore holes in the paint where they had bumpers between the shield and hood. When we purchased it, it had no shield, nor will I add one. I've had plastic shields on vehicles in the past, and have had a number of issues with them:
o washer fluid doesn't reach windshield when at highway speeds
o debris gets trapped between shield and hood
o rust/rot in holes in underside of hood where screws hold the shield

A stainless shield would make sense if there was no gap between the hood and shield, but then it probably wouldn't have the kicker at the top edge.

Ford hoods are plastic/fiber anyway, so they won't rust even if the paint is chipped.

We clean the bugs off with purple power or any good cleaner, then give it a coat of wax now and again. It works for us.

I just energize my defense grid. :)

Steve

I had a Lund Bug Shield on my P/U and at 65 MPH I could wash the hood - and not the windshield. It created a low pressure zone over the hood that the washer fluid followed. Would I put a bug deflector on my Class C? The low pressure zone in front of the windshield is bad enough. I believe that a bug shield would only make it worse. I've had the pleasure and dismay of watching large insects get trapped in the zone, as well as a gold finch strike - only to watch the deceased bird slowly slide from right to left across the windshield. No, I wouldn't install a bug shield.

I put one on a Chevy chassis Class C, a few years back and it worked. The only negative I found was at road speed, the windshield washer fluid would seldom make it to the windshield, as intended. However, I did break a couple of the plastic ones (bug deflectors) by them stopping rocks and other road debris that was thrown up by other vehicles. Found a stainless steel one, I think it was at Cabelas in their RV catalog that lasted and was on the rig when we sold it. Some bugs are going to stick to the front, no matter what you do, so just the price paid of having fun. LOL

try spraying the WD-40 on the cab over.

Path1, thanks for your input. I like the idea of adding some metal protection to the front of the house down low as this area will surely catch road debris over time. Given the relatively low cost of adding a deflector I may just go ahead and try it with low expectations and hope to be pleasantly surprised.

I do keep the entire coach waxed, I have been using Nu Finish with good results for years. This helps when it comes to bug removal and the used Bounce dryer sheets also work very well but it is a long reach/stretch. Yes the Nexus is new (to us), it is a 2012, Arizona does not use front plates. :C

Desert Captain wrote:

You took perfect pic.

Make that surface so slick that bugs just slide right off!

Sound like witchery? Maybe, but...Believe it or not, there are products out there that claim to prevent bugs from sticking to automotive surfaces. Could be worth a try.

Here's a link to one such product.

I'm thinking that you'd need one of the 'taller' deflectors-so that it has a shot at pushing the air straight up towards the face of the cabover rather than towards the roofline as normally would be the design...

I have a better idea. When on the expressway, find a Class A or a semi and tailgate them. Let them deflect all the bugs. :)