Direct TV HD set up

2oldman wrote:
Been doing this for years. At first it was a challenge, especially because there were no beeps in the HD receivers. They are back now, which helps a great deal.

Do all Directv HD receivers have the audible signal strength meters?

Also, I have always thought there was a little lag time between when the sat antenna locked on the HD signal and it registered on the signal strength meter. Maybe I'm wrong.

2oldman wrote:

Carl n Susan wrote:
I know one person who uses the old style "Squeal-o-meter" to home in on the satellites.

You mean the receiver beeps?

I believe it's recommended to shoot the 101 with no skew. I find skew to be the least important setting.

That is not the recommendation. Unless you are in the Central US (along a N/S line including the E/W borders of TX) then you need to set the skew to get a good signal from 99 and 103.

I agree with two old men . TV4RV tripod. Its the way to go. That what I have used for about three years. I just use a cheep sat finder. After that I fine adjust while my wife watches the signal power.

Carl n Susan wrote:
I know one person who uses the old style "Squeal-o-meter" to home in on the satellites.

You mean the receiver beeps?

I believe it's recommended to shoot the 101 with no skew. I find skew to be the least important setting.

I have been doing DTV HD with a portable antenna for the last 6 years. Once you get the hang of it, it normally takes under 10 minutes start to finish. Start with a good tripod (like others I use and recommend the TV4RV one). Get it level and oriented towards the satellites. Use one of the dishpointer apps on your phone to ensure there is a clear shot to the satellites. I use the dishpointer.com web site to get the specific azimuth, elevation and skew for my location. (hint: do it ahead of time and then you are ready to setup as soon as you arrive). Set the elevation and skew on the antenna before you mount it on the tripod. A compass will show you where to point the antenna. Plop the antenna on the mount and you should be close. To home in on the signal I use a Sat Look Lite signal finder. But others use the receiver and its builtin signal meter. I know one person who uses the old style "Squeal-o-meter" to home in on the satellites. The key is to lock in on the 101 satellite. Do that and 99/103 will also be there (assuming the skew is anywhere close to the prescribed value).

starcraft69 wrote:
I would love a dome self finding but don't want to purchase and have it be no good when they make there changes. Plus i really want HD we have such nice TV it seems a waist to watch in SD.

I don't think you'd have a technical problem with the dome, but they're just so darned expensive!

It is a waste to feed it SD.

Thank you everyone!!!!! With the uncertainty of Direct tv and standard def I think this is the best way to go. I would love a dome self finding but don't want to purchase and have it be no good when they make there changes. Plus i really want HD we have such nice TV it seems a waist to watch in SD.

Been doing this for years. At first it was a challenge, especially because there were no beeps in the HD receivers. They are back now, which helps a great deal.

My best advice to you is to get a GOOD TRIPOD. Tv4rv is a good online shop to find them. Slimline dishes are heavy, so you need a good base which is easy to adjust and get plumb. Getting it plumb means the gradations for elevation on the dish will be correct. And, when set up properly, they stay where you put them and don't allow the dish to get off signal in wind. Make sure you also get a dish with the proper post to fit into the tripod.

It's really not much more difficult to setup an HD dish as it is the 18 inch. The 3 satellites are right there side by side so you do the same routine you would do to locate the 101 satellite but you have to add in a plumb and level mast (very important) and then just set the skew (tilt) for the dish to the appropriate angle. It should not take more than a few more minutes to get it all set.

I use a multi-sat dish (18x22) with a SL3 lnb for HD. If you plumb your small diameter post (you can use your current tripod with a multi-sat dish) and then set the skew all you have to do is peak 101 and your done.