Forum Discussion

Horizon170's avatar
Horizon170
Explorer
Nov 05, 2016

DYI Antenna Mount--Red Neck style

1. 4x4 with screws added for snug fit to bumper. Hole drilled through center. Recessed hole for nut and washer.

2. 4x4 (SHORT) to hold antenna base.

3. Bolt tightened to secure 3/4" all thread from moving.

4. Dish base added (I am lacking one nut to secure it tight--Hdwr store monday.)

When tight and in place and PLUMB I will secure level.


Now I can adjust left and right with the antenna base and Fore and Aft with the 3/4" end nut. That will tighten the short 4x4 against the 4x4 inserted in either side of the rear bumper.
Red neck engineering to the rescue.
I just can't be headed straight into the satellite and I can't be where trees will interfere with line of site.

23 Replies