Sensar 4 antenna problems
Replaced old sensar 2 antenna with new sensar 4 with wingman. Getting 12 volts to new antenna head , but no signal. Any suggestion other than replace. Anyone know wArranty on winguard antennas. ...
Forum Discussion
Suspect #1 is the coax end (Connector) if the center wire is cut a bit...short.. it may not be making contact with the center pin in the antenna.
Suspect #2 is the other end of the "Above the roof" coax where it connects to the longer run at or in the roof.
To test
Get a length of coax RG-6 or 59 don't matter. Long enough to reach from teh power source (Box of many buttons, wall plate. Sensar Pro) to the roof top antenna via window or door. Run a direct line. if it works. Then clearly a coax issue.
Suspect #2 is the other end of the "Above the roof" coax where it connects to the longer run at or in the roof.
To test
Get a length of coax RG-6 or 59 don't matter. Long enough to reach from teh power source (Box of many buttons, wall plate. Sensar Pro) to the roof top antenna via window or door. Run a direct line. if it works. Then clearly a coax issue.
