Winegard Travlr SK3005
Lately my sat is not showing an * by the 110 sat and I'm getting a Direct-tv (HR54-200 receiver) 771 code on some channels but not consistently, does it 1 day then the next it may connect fine. Lookin...
Forum Discussion
Start by performing the Calibrate EL routine and then do a new search to see if that helps. Not seeing a * by 110 means it could not find the 110 satellite and it's possible that you are in an area with some trees causing a blockage. If the antenna cannot see at least 2 satellites it cannot properly set the skew and that would cause signal loss as well.
Take a look at the dish itself and see if it is tilted to one side or the other (unless you are in the center of the US where skew is not necessary).
You may also need to check the connections in your SWM8 setup. Between the SK3005 and the receiver you would have installed this switch and Power Inserter (different PI than the one at home) so make sure that equipment is OK as well.
Take a look at the dish itself and see if it is tilted to one side or the other (unless you are in the center of the US where skew is not necessary).
You may also need to check the connections in your SWM8 setup. Between the SK3005 and the receiver you would have installed this switch and Power Inserter (different PI than the one at home) so make sure that equipment is OK as well.
