Anyone replace their tank sensors?
I have purchased new sensors for all my tanks. They are the button sensors like what is on there. I was wondering if anyone has any experience in replacing theirs? If so did you drill a new hole or re...
Forum Discussion
Lynnmor wrote:shadows4 wrote:Lynnmor wrote:
Why do people think that the "sensors" are something special? It is just a simple bolt thru the tank wall that gets dirty. The dirty tank walls are a problem as well. I built a device to compensate for the current conducted by the dirt and it worked well this past season.
Care to share?
When I posted about my device before, I got nothing but nonsense from the usual nay-Sayers.
http://www.rv.net/forum/index.cfm/fuseaction/thread/tid/27618811/srt/pa/pging/1/page/1.cfm
CLICKY
Way too much time involved in worrying about tank sensors.
Are you going to constantly 'adjust' resistance based on how clean/dirty probes are?
And how are you going to measure the amount of clean/dirty?
Toilet 'burps' time to dump black tank
Sink/shower starts to drain slower than usual..time to dump grey tank
On-board pump goes burrrrrrrr and no water from faucet....should have added more water to fresh water tank when dumping holding tanks
RVng is about FUN!
:B:B
