Did my Andersen No-Sway WDH do this???
Or did the trailer service center? I'm not sure, what caused it, but after hooking up last night I noticed chunks of aluminum on the ground under my setup. I had just got my trailer back from serv...
Forum Discussion
Is the coupler on the trailer an 88xxx series Atwood? If so, that coupler is not compatible with the Andersen and may be the issue.
Atwood 88xxx coupler not compatible
There seems to be a LOT of negative tilt in the hitch head back towards the vehicle which may be pointing the plate at the bottom of the frame. This should be missing the frame…
here is a pic to illustrate this
There is a clearance issue with your frame.. that is for sure..
Its also interesting that the weld itself pealed out of the frame.. I would think the weld would be stronger than the surrounding aluminum.
It looks like your coupler actually angles up away from the frame some instead of down towards the bottom of the frame.
Thanks!
Jeremiah
Atwood 88xxx coupler not compatible
There seems to be a LOT of negative tilt in the hitch head back towards the vehicle which may be pointing the plate at the bottom of the frame. This should be missing the frame…
here is a pic to illustrate this
There is a clearance issue with your frame.. that is for sure..
Its also interesting that the weld itself pealed out of the frame.. I would think the weld would be stronger than the surrounding aluminum.
It looks like your coupler actually angles up away from the frame some instead of down towards the bottom of the frame.
Thanks!
Jeremiah
