Drilling Hole IN I Frame
I am in the process of installing a black tank flush kit. There is no access to the side of the trailer for the Black Tank rinse inlet unless I drill a hole in the 10" I frame. Can I drill a 3/4 hole...
Forum Discussion
I was planning on using a flush mount water inlet not the one that comes with it to make it look more like a factory installation.
I was going to install the Tornado device in the tank and hard plumb the water line using 1/2 pvc or pex tubing. I also was thinking of using clear braided tubing.
My black tank is open with no coroplast covering but the bottom of the trailer is sealed above the tank with a fiberglass mesh and I really don't want to cut through it.
The hole I need to drill in the frame is just forward of the front axle. I don't think it would be a issue. the I frame is 10" but it has absolutely no holes in it.....
Now I am beginning to think I am making it way harder than I need to..
I was going to install the Tornado device in the tank and hard plumb the water line using 1/2 pvc or pex tubing. I also was thinking of using clear braided tubing.
My black tank is open with no coroplast covering but the bottom of the trailer is sealed above the tank with a fiberglass mesh and I really don't want to cut through it.
The hole I need to drill in the frame is just forward of the front axle. I don't think it would be a issue. the I frame is 10" but it has absolutely no holes in it.....
Now I am beginning to think I am making it way harder than I need to..
