Dual Cam setup
So I set up the dual cam last year. the truck rode great. the only issue was some sway during wind gusts, large trucks or line of cars passing and some bouncing from the rear end. I just put new lt t...
Forum Discussion
Find a level spot (parking lot etc)
Drive (track) the truck 75 to 100 feet straight, get out and look at the cams.
Adjust both to be spot on centered.
Mark bars left and right and once set, do not flip flop sides, keep the WD bar on the same side. They are forged bars, not machined, they are not the exact same length.
Drive around again, re-track the truck straight and check again.
Hope the helps
John
Drive (track) the truck 75 to 100 feet straight, get out and look at the cams.
Adjust both to be spot on centered.
Mark bars left and right and once set, do not flip flop sides, keep the WD bar on the same side. They are forged bars, not machined, they are not the exact same length.
Drive around again, re-track the truck straight and check again.
Hope the helps
John
