Dual Cam Setup
I'm working on setting up a new Reese Dual Cam setup. I think I need a 1" extended ball, and wonder if I would benefit from a 2". Here's are some photos of where I'm at now: Side view, I think...
Forum Discussion
JBarca wrote:
I'm "assuming" you really did not know you had a problem until after the short trip you made, right? Meaning you did not hear a bang or anything, just you pulled out of your drive, went for a ride, got to the end of the trip got out and found this mess? Yes or no? Any bangs, snaps or noise of anything?
Correct. There were noises, but as far as I know these are the typical noises you get when turning. Nothing jumped out as different than any other day.
I do get some creaks and pops when turning - I thought that was par for the course - metal on metal, cam popping in and out, etc.
