Dual Cam Setup
I'm working on setting up a new Reese Dual Cam setup. I think I need a 1" extended ball, and wonder if I would benefit from a 2". Here's are some photos of where I'm at now: Side view, I think...
Forum Discussion
Dual Cam Mount:
Dual Cam Pinch Bolt
Bottom of snap up:
Snap up pinch:
Threaded area (I knew this was an issue and Reese was sending rivnuts - probably need something beefier than that now...)
One more possibly important piece of the puzzle:
Also I went out and hooked up everything to double check clearances with just the drive side bar attached and moved the hitch around. I didn't see anything obvious.
Also, no obvious gouges or missing (or new rubbed on) paint on the bar, ball or dual cam.
Dual Cam Pinch Bolt
Bottom of snap up:
Snap up pinch:
Threaded area (I knew this was an issue and Reese was sending rivnuts - probably need something beefier than that now...)
One more possibly important piece of the puzzle:
Also I went out and hooked up everything to double check clearances with just the drive side bar attached and moved the hitch around. I didn't see anything obvious.
Also, no obvious gouges or missing (or new rubbed on) paint on the bar, ball or dual cam.
