Dual Cam Setup
I'm working on setting up a new Reese Dual Cam setup. I think I need a 1" extended ball, and wonder if I would benefit from a 2". Here's are some photos of where I'm at now: Side view, I think...
Forum Discussion
Ron Gratz wrote:JBarca wrote:John, is this the thread you were thinking of?
Maybe you remember the post we both talked about spring bar deflection. I have searched now for over an hour and cannot find it...:( Yet you linked it in to a thread not that long ago... so maybe you have it book marked.
http://www.rv.net/forum/index.cfm/fuseaction/thread/tid/23526339/gotomsg/23572007.cfm#23572007
I cannot find any earlier thread in which you posted your load-deflection data -- but it does seem to me there was one.
Ron
Thanks Ron, I found that in the Pullrite thread too. I know there was a post as I recall you helped point out the error that could occur with the way I did it. At the time I could not think of how to hold the end of the WD bar rigid enough and then just preload the end of the bar. OH well, it will turn up some day.... Thanks for looking.
John
