Dual Cam Setup
I'm working on setting up a new Reese Dual Cam setup. I think I need a 1" extended ball, and wonder if I would benefit from a 2". Here's are some photos of where I'm at now: Side view, I think...
Forum Discussion
TUCQUALA wrote:
What do the experts think of the use of washers to get the cam bracker properly positioned in Mrekim's case?? Could that have increased the forces at the bolts since there would be less frame contact with the bracket?? Could the bracket have resisted the twist forces with full contact?? My brackets are flat against the frame both on the side and bottom of the frame and have exhibited no loosening or bending in the frame. Agin, just a thought!!!
I'm not claiming to be an expert....
I would say if the brackets are tight to the side and bottom then don't add washers. The radius at the bend on the outside of the frame bracket is pretty big, does that radius match your frame radius?
