Dual Cam Setup
I'm working on setting up a new Reese Dual Cam setup. I think I need a 1" extended ball, and wonder if I would benefit from a 2". Here's are some photos of where I'm at now: Side view, I think...
Forum Discussion
Ron Gratz wrote:
we need to be able to measure the bar load directly or calculate it from curvature measurements.
I'm expanding on a previously posted suggestion for measuring the bar load...
What if a rigid bar ( a dowel or maybe a fiberglass rod) where taped to the the bar near the trunnion and some measuring scale was fixed to the bar at the other end - maybe to the chain.
If we had such a setup, then measurements could be taken for various scenarios. And, possibly, these loads could be captured via a camera (like a gopro) so the dynamic/"in motion" forces could be captured as well.
