Dual Cam Setup
I'm working on setting up a new Reese Dual Cam setup. I think I need a 1" extended ball, and wonder if I would benefit from a 2". Here's are some photos of where I'm at now: Side view, I think...
Forum Discussion
JBarca wrote:
Your present TW by your Sherline scale at the time the test is done.
950 Lbs (Measured 2x and got same value)
JBarca wrote:
How much pointer deflection was measured from a relaxed WD bar (no load) to WD engaged just from hitching up?
1 3/8" (From above).
JBarca wrote:
How was WD adjusted on the truck in regards to truck front end position?
Difference between WD and no trailer:
Driver front RAISED 1/16"
Passenger front RAISED 1/4"
Driver rear raised 7/8"
Passenger rear raised 1 1/8"
So the WD is lowering the front a little currently.
The propane tanks are installed and approx 1/2 full. The spare tire is in the back of the Excursion not under the tongue. The front storage is empty as is the storage under the front bed. Hopefully that accounts for the front TV changes vs my previous setup. I'm pretty sure the previous setup - with trailer loaded and ready to go - the front was 0 and RAISED 1/16" when trailer was removed (very slight transfer to front wheels). The tongue weight was 1080 lbs.
