Forum Discussion
charles_cincy
Mar 14, 2015Explorer
CHD Dad wrote:
No, shank only works in the down position since it's all cast as one piece.
Page 5 of the installation manual says: "NOTE: To obtain proper ball height on low ground clearance tow vehicles, shank may be oriented in
the “UP POSTION” as shown in Illustration 4. If shank is used in the “DOWN POSITION, check shankfor adequate ground clearance. Accessory shanks with greater height and length are available from your dealer. IMPORTANT! Proper adjustment requires the use of the proper length shank; proper head height and proper head tilt adjustment."
Manual PDF
About RV Tips & Tricks
Looking for advice before your next adventure? Look no further.25,108 PostsLatest Activity: Feb 08, 2025