Entrance door lock trouble

Jackfate wrote:
I’d like to replace JUST the cylinder lock core itself and not the whole door latch assembly. I know it can be done & you need the lock to be unlocked and a core pulling key but can’t seem to find it in a internet search. I don’t apparently have the wording right to get the results I’m looking for . I may just buy a new latch assembly, probably cheaper in the long run

Thanks

The cylinder is removed by removing the clip on the back holding it in the lock, inserting a key that works, turning it 45 degrees or so to prevent the pins from falling out, then pushing the cylinder out with a plastic or wood cylinder of the same diameter. If there is no working key, you may be able to pick the lock. Some locks have access to the pins; once they are uncovered and the top pins, tumbler pins and springs are removed, then the cylinder can be pushed out.