Forum Discussion
ScottG
Dec 02, 2017Nomad
That regulator is attached with a common 1/8" NPT. Simply remove it and use a couple of brass fittings to connect it either to a rubber gas line permanently or connect a quick disconnect where the regulator was.
Example:

Note the inside of the QD was drilled and tapped but I just as easily could have used a fitting to adapt it.
Do the same for every gas appliance, like this fire pit.

Example:

Note the inside of the QD was drilled and tapped but I just as easily could have used a fitting to adapt it.
Do the same for every gas appliance, like this fire pit.

About RV Tips & Tricks
Looking for advice before your next adventure? Look no further.25,130 PostsLatest Activity: May 11, 2025