Revisiting rust on propane tank

Just trade it in.

Don't "discard" it. In fact, why bother with the rehab. Trade it in at your nearest propane exchange center. Unless, of course, it's not a 20 lb tank. I don't know of anyone who exchanges 30 lb tanks.

ASME tanks are made from pretty thick hard high carbon steel.

If the tank is rusted enough to be condemned I’m pretty sure the RV frame that it’s bolted to is LONG past being safe to go down the road.

You don’t need to get down to “bare” steel, you just need to get all the loose rust off and slather it in white rust paint.

Jax, I will take your advice and get surface rust off and put proper follow up rust protections on. Onan tech who removed my old no good genset told me the frame rust was only surface rust. Doug

+1 to remove the bulk and smooth the surface a bit and paint with a rust inhibiting paint.

I have had good luck on truck and trailer frames with POR paint.

Is this one of those removable bottles or one of those built ins like on a class A?

JaxDad wrote:
ASME tanks are made from pretty thick hard high carbon steel.

If the tank is rusted enough to be condemned I’m pretty sure the RV frame that it’s bolted to is LONG past being safe to go down the road.

You don’t need to get down to “bare” steel, you just need to get all the loose rust off and slather it in white rust paint.

That... Is a post I agree with.. If the tank is that far gone odds are the RV is too... My last car was fast approaching that point when the settlement check arrived for my RV (It got totaled. which as I discovered later was very likely a very good thing for multiple reasons) my "new" used JEEP has many years left.. Save for one foot that leaks.. about 2PSI per week.

Not a portable tank. Thanks for the replies. Doug

you could always prime/seal with phosphoric acid. Coverts iron oxide into iron phosphate which is inert. Same principle as POR. Stuff was available in the paint prep section at Home Depot when I bought it.

Google should expound on the subject.