3d printers for making stuff for the RV
I have fallen down the worm hole of 3d printing since Christmas, and was wondering if anyone else on here is playing with them. If so, how you use them when it comes to RV's. I can see them being ...
Forum Discussion
StirCrazy wrote:LittleBill wrote:
I am using petg here. that said I do have touch of warp in 3 corners, i turned the bed up a touch. hopefully it stays in place. its over half a roll of filament for it.
is that garolite?
Hairspray cured my warping on big prints.
what are you making a base for a light?
i despise glue and hairspray. I understand a lot of people use it, If it fails i will run a hotter bed. this is the first failed print, in the last 100, (also my largest)
if you look back the post with pictures, there is a link to what its for. its a base for an autoformer.
