3d printers for making stuff for the RV
I have fallen down the worm hole of 3d printing since Christmas, and was wondering if anyone else on here is playing with them. If so, how you use them when it comes to RV's. I can see them being ...
Forum Discussion
While I'm talking about the enclosure, here's a hardware design tip someone might find useful.
I embedded 6-32 nuts in knobs by creating a clearance hex slot in the knob and press the nuts into place. I use these as retainer nuts to secure the plexiglass as well as handles on the plexiglass to make it easy to remove and handle.
I shouldn't of recessed the plexiglass panels as I did. I gave up internal real estate doing this.
I embedded 6-32 nuts in knobs by creating a clearance hex slot in the knob and press the nuts into place. I use these as retainer nuts to secure the plexiglass as well as handles on the plexiglass to make it easy to remove and handle.
I shouldn't of recessed the plexiglass panels as I did. I gave up internal real estate doing this.
