3d printers for making stuff for the RV
I have fallen down the worm hole of 3d printing since Christmas, and was wondering if anyone else on here is playing with them. If so, how you use them when it comes to RV's. I can see them being ...
Forum Discussion
2112 wrote:
Design Time?
How long did it take you to design the grill in as opposed to leaving it out and add some channels along the ledge to let the water out? You quadrupled your print time and used up a lot of material.
If it's a one-off so be it. But what if you need to print 200 units?
surprisingly that grill went together pretty fast, it was the edge angle that took a couple minutes. But again, I didn't think of doing it that way, no I don't plan to sell them, they take too long and cost too much compared to what is on the market already.
