anode rod threads
The threads in my suburban water tank have gotten kind of corroded. I am putting a new anode rod in, but it will not turn in very far. The threads are not stripped, but need a good clean out. Does ...
Forum Discussion
Thanks all, for the replies!
With the new rod, I am only getting it to turn in a couple of threads, before it is tight. It leaks a little, even with the teflon tape. I don't want to over tighten it, with only a few threads catching.
I used a dental pick, that helped some, but I think I'll try the round wire brush idea.
The only pipe thread chaser I could locate was just over $70. I don't feel like getting robbed!! Lol
Thanks again,
Jerry
With the new rod, I am only getting it to turn in a couple of threads, before it is tight. It leaks a little, even with the teflon tape. I don't want to over tighten it, with only a few threads catching.
I used a dental pick, that helped some, but I think I'll try the round wire brush idea.
The only pipe thread chaser I could locate was just over $70. I don't feel like getting robbed!! Lol
Thanks again,
Jerry
