Atwood hot water tank wouldn't stay lit...
As the title states, my Atwood wouldn't stay lit when we arrived at the site earlier today, I searched this forum and found that many resolve the issue by cleaning the orifice...so I slid the air mixt...
Forum Discussion
Flame sensor or thermal couple not directly in flame
Corroded ground wire on LP gas valve
Dirty connection on circuit board
Bad ECO
Bad thermostat
Dirt orifice needs to be removed from gas valve, soaked in alcohol, blow it out and then reinstalled. Do not use any type of device to clean.
Depends on model of course!
Corroded ground wire on LP gas valve
Dirty connection on circuit board
Bad ECO
Bad thermostat
Dirt orifice needs to be removed from gas valve, soaked in alcohol, blow it out and then reinstalled. Do not use any type of device to clean.
Depends on model of course!
