Atwood water heater G6A-8E Remote Switch

Old Biscuit- someone commented on an earlier thread that I'm "not a tinkerer", and he was right. I'm always afraid I'll screw something up even worse. That's a shame though because this is/was such an easy fix that a little tinkering would have taken care of it and I wouldn't have had to bother people here on this forum. I pulled off the inline fuse you mentioned, checked continuity, and the fuse WAS good. All I did was put it back in place, pushing the spade ion and off a couple of times to clean it a bit. Ten seconds later I was a little shocked when the igniter lit up. I'm very embarrassed, but it looks like all it needed/needs is a little clean up. I'll do a more thorough job in the next few days of cleaning ALLthe contacts. Thanks so much for your generous help,