Atwood/Dometic furnace motor updates?
Got a Atwood 8012-II furnace that is starting to chirp so I'm guessing that I'm going to have to replace the motor in the near future here. Looking up the part shows the original motor is part number ...
Forum Discussion
I’ve had good luck lubricating those motors- as long as the shaft isn’t worn, I drill a hole in each end bell and apply oil to soak the felt.
First did it after I installed a brand new defective motor (it squealed), and the customer was leaving.
Was still working years later.
First did it after I installed a brand new defective motor (it squealed), and the customer was leaving.
Was still working years later.
