Dometic/Atwood Furnace AFMD30... grrr cntl board
So as we discussed in another thread, i pulled the stove out and went to work cleaning lint out that may have been blocking air flow. I had complained of the flame cutting off/on during cycle.
I cleaned around any slatted vents in the enclosure.
I went outside, pulled the plastic cover, pulled lint out there. Also had one of those cheap $1 little paint brushes handy and used that to brush off static dust.
FURNACE NO STARTY....
Today i troubleshooted it to the control board.
12v is on the wire that plugs into board.
But when i attach it to the board, its zero volts.
No action on the little red LED.
Do you guys agree that its the board?
What Dinosar board do i order?
I cleaned around any slatted vents in the enclosure.
I went outside, pulled the plastic cover, pulled lint out there. Also had one of those cheap $1 little paint brushes handy and used that to brush off static dust.
FURNACE NO STARTY....
Today i troubleshooted it to the control board.
12v is on the wire that plugs into board.
But when i attach it to the board, its zero volts.
No action on the little red LED.
Do you guys agree that its the board?
What Dinosar board do i order?
