Auto xfer switch

Or reconfigure the whole house so utility power only goes to air conditioner and a battery charger. Rest can be 100% inverter.

If you are concerned about the rebooting of the satelite receiver get a small inverter and run it off the batteries.

enblethen wrote:
I don't know why you would want one bassed on high switch rate as many have time delay

Don't want no stinkin' time delay.

2oldman wrote:
I wonder if that's fast enough for a DTV receiver.

The Samlex one can be adjusted down to 20ms.

Try Best Converter
Best converter
I don't know why you would want one bassed on high switch rate as many have time delay.
This one is around 26ms
26MS switch

2oldman wrote:
My defunct Prosine had a very fast xfer switch

Hmm.. it's not possible to take that switch out and use it.. is it?

smkettner wrote:
Samlex says 25ms.

I wonder if that's fast enough for a DTV receiver.

smkettner wrote:
Aims 26ms

Good find.

Samlex says 25ms

http://www.donrowe.com/v/vspfiles/assets/images/STS-30_spec_sheet.pdf

Have to disable the generator delay.

CA Traveler wrote:
My DTV receiver will reset when power is switched on my rig and it then takes several minutes to activate again.

My defunct Prosine had a very fast xfer switch which would make the generator-to-inverter transfer sans disturbing the DTV receiver. I would like to have that functionality back again in my current setup.

smkettner wrote:
Aims 26ms

That looks like the one SM.. thanks.