High Voltage drop to slide motor
Good day folk :) I just purchased a 2017 Sportman Classic 181BH. I noticed the slide felt "sluggish" like the motor is not getting proper juice. Decided to do a test and by-pass existing wiring a...
Forum Discussion
RasMouSein wrote:
@ time2roll
Use of 2 dpdt relays
Something like this would work.Click For Full-Size Image.
It is looking like the controller for my slide out is ...toast.
possible the motor too but the tech is due out like tomorrow to test that (Should have earlier but alas)
I told her I could design a control system that was a bit more manual but retained the safety interlocks... Alas, you beat me to it, (My design is identical to yours
One change I will suggest.
On each relay, a MICROSWITCH, that will open when the slide is either FULLY OUT (for that relay) or FULLY IN for hte other (AKA Limit switches)
All Electronics (dot com) has all the parts near as I can tell for less than 50 bucks total. Which means it would NOT qualify for free shiping. (Not a problem. I can always find other good Junque there).
