NOW..........NO HOT WATER AT ALL!!!
Re: Suburban WH type 2nd owner to my 5th that has dual HW heating and not a single piece of repair history before I bought it in June 2016. Anyhow, I got hot water both by LP and elect with no pr...
Forum Discussion
Suburban Model is # SW12DE btw.
Mandalay & Old-Bis (others of course!), following both suggestions. 1st being retrace my steps of what I disturbed and 2nd, did I disturb the electrode placement?
On the Thermo LP spades, I noticed that they were flopped up and I thought out of place? So I depressed them back down parallel (just like the Elect spades). Was that a no-no? Would it make a difference?
Next, when replacing the gas pipe it was very stubborn to line that one bolt back into the "frame lined hole" so I placed a screwdriver on top of the pipe and kinda pryed it down and shimmied into place. Perhaps I disturbed the path and correct position of the 2 electrodes? Are they supposed to be heavily engulfed into the flame or just hoovering over the flame? I will have to look, but certainly hope I did not crack the ceramic on the electrode body? That should be visible yes? But assume it would fall out if so? But putting that aside, interested in the electrode placement right now?
Mandalay & Old-Bis (others of course!), following both suggestions. 1st being retrace my steps of what I disturbed and 2nd, did I disturb the electrode placement?
On the Thermo LP spades, I noticed that they were flopped up and I thought out of place? So I depressed them back down parallel (just like the Elect spades). Was that a no-no? Would it make a difference?
Next, when replacing the gas pipe it was very stubborn to line that one bolt back into the "frame lined hole" so I placed a screwdriver on top of the pipe and kinda pryed it down and shimmied into place. Perhaps I disturbed the path and correct position of the 2 electrodes? Are they supposed to be heavily engulfed into the flame or just hoovering over the flame? I will have to look, but certainly hope I did not crack the ceramic on the electrode body? That should be visible yes? But assume it would fall out if so? But putting that aside, interested in the electrode placement right now?
