Optimum Manual Charging Scheme?
I'm looking for a general description of an "optimum" charging cycle for a 100ah - 160ah AGM battery bank. Let's say that I'm using my Meanwell power supply, adjustable 15v 13.4A. Let's imagine ...
Forum Discussion
Good point. I should have quoted the following from the side of the 35ah batts (I have three):
Cyclic Use: 14.5v - 14.9v, 10.5a
Standby use: 13.6v - 13.8v, 5.25a
I'm seeing a lot of French talkin there, and nothing about time and not much about set points. Do I just sit there pumping those batts with 14.6 until they read 14.6 and then drop to 13.6? What if I'm drawing at the same time, say 200 watts in and 80 watts out?
It is very easy for me to monitor the batts because they sit next to my desk in the tent (ventilated better than a wind tunnel).
Again, yelp!
Cyclic Use: 14.5v - 14.9v, 10.5a
Standby use: 13.6v - 13.8v, 5.25a
I'm seeing a lot of French talkin there, and nothing about time and not much about set points. Do I just sit there pumping those batts with 14.6 until they read 14.6 and then drop to 13.6? What if I'm drawing at the same time, say 200 watts in and 80 watts out?
It is very easy for me to monitor the batts because they sit next to my desk in the tent (ventilated better than a wind tunnel).
Again, yelp!
