RULER reading???
Need to drill a hole for a hitch pin Have the 5/8in hitch pin and need to drill a hole a bit bigger. The size I need is 2 lines after the 5/8 in on the below pictured ruler. What size drill bit ...
Forum Discussion
BobsYourUncle wrote:
Top of your tape is in 1/16ths increments.
Bottom of the tape is in 1/32" increments.
Your drawn on pointer indicates 11/16"
It's not 3/4"
I wouldn't drill larger than 5/8" for the pin. Even drilling 11/16" will give you a loose fitting pin.
Drill 5/8, then try it, it will likely be ok. If it's a touch tight, run the 5/8 bit in and out a few times. This will knock about a 64th more off the hole and should be ample.
If you absolutely have to go bigger, seek out a 21/32" bit, no bigger.
You don't want it too loose.
Do remember, you can always drill it a bit bigger, but you can't drill it smaller!
That sounds good. I will try the 5/8's first and see what happens and now I know that its 11/16th if need to be bigger I know what it is...that 11/16 measure was from the hole in the existing tow hook that I have. I bought one of those 4 in 1 balls and all the others fit the hole except the 2" ball which was the one I needed. did not fit the existing hole in the receiver therefore have to drill one. like this one
tow hook
