Forum Discussion

joebedford's avatar
joebedford
Nomad II
Apr 30, 2016

Schwintek slide - how to access motor / harness on 2011 unit

I'm getting an error code of 8.2 on my bedroom slide Schwintek controller: Hall effect signal not being received from motor two. Result is that the slide rear moves fine but front moves a couple of in...
dougrainer's avatar
dougrainer
Nomad
Jun 15, 2016
joebedford wrote:
Popped the new motor in today. After two cycles, the controller successfully resync'd the motors.

Now to repair the wiring on the old one so I'll have a spare.


To Synch the motors is simple. You just hold the extend and retract button for 15 seconds AFTER the extend or retract. THAT synchs the motors in the module memory. Doug

About Technical Issues

Having RV issues? Connect with others who have been in your shoes.24,194 PostsLatest Activity: Jan 29, 2025