Forum Discussion

joebedford's avatar
joebedford
Nomad II
Apr 30, 2016

Schwintek slide - how to access motor / harness on 2011 unit

I'm getting an error code of 8.2 on my bedroom slide Schwintek controller: Hall effect signal not being received from motor two. Result is that the slide rear moves fine but front moves a couple of in...
joebedford's avatar
joebedford
Nomad II
Jun 16, 2016
LCI tried to help me. They responded to my queries both email and phone but I didn't seem to be able to make them understand that my rig didn't have motor removal slots. Or, maybe for liability reasons, they didn't give somebody advice who's going to go at the thing with an angle grinder and cutoff wheel.

The whole thing was a royal pita - a little more advice from LCI would have helped me a lot.

About Technical Issues

Having RV issues? Connect with others who have been in your shoes.24,191 PostsLatest Activity: Jan 19, 2025